Parts 1uz to w58 bellhousing adapter

[the ghoul]

Hey guys
Just finished fabricating up my bell housing adapter for my 1uz swap into my 84 supra. Im in the habit of making a few parts at the same time, so that way if I have to scrap one for some reason I will have backups. Well this has lead me to have an extra adapter plate.

This was fabricated using these plans
http://www.v-eight.com/tech_forum/viewtopic.php?f=40&t=753
(and yes i plan to make a donation from the proceeds from this sale)
The adapter plate was laser cut from 3/8" A36 steel
The centering plate was laser cut from 3/16" A36 steel
They were welded together using steel dowels for correct alignment before the holes were finish drilled and tapped
The plates were also shot-peened before finish drilling and tapping (but after welding)
The plate you see here in the pictures is the one you will receive

Im asking $200 shipped any where in the 48 (us) states

 

[the ghoul]

sold thank you!

 

[the ghoul]

just had 4 of these made,
after the holidays i will have a product run of about 10 made.
at that point i will sign up for a vendor account and start offering these and MKII specific swap parts

 

[el_diablo]

if you do any that go from 1uz to r154 i'm about 99% sure i'll take one off your hands i dont think the w58 will hold the power of the tt setup just pm me if you end up making some

 

[scandy001]

I want one for the w58... I thought they were stronger then the r154s???

 

[el_diablo]

my buddy trashed 4 or 5 w58's and went to the r154 and has had no prob since

 

[Smitherz]

Yeah the W58 is in NO WAY as strong as a R154. The W58 is also smaller in every way.