Zuffen

hi zuffen.

i need help with my g/box wiring. on which pin do i connect the etc-pwr switch and on what pin does the o/d button go? ecu-3a240 1uz non-vvti a341e
as best i can tell there's no OD2 pin. there's a PWR-(28pin5) PWRL+(28pin6) and OD1(28pin7).

appreciated
hugo

Greetings from Russia.
Tell me please where can I find the tuning section and improvements on 1uzfe. build a car for drift. so where is better to snap spare parts

hiya Zuffen

i wish to swap a pajero 1997 with tiptronic automatic gearbox with a 1uzfe.....

was wondering if yourself could nudge me in the right direction

Hi
I messed up and put my trans question in the alternative fuel section. Can you delete my post?

Thanks

are you able to help? The whole forum is 404 not found error!

Hi Rod,

Sorry for the slow reply, haven't logged on here in a while.
Yeah the adapter and flywheel is done, now I need to get the engine running to see what happens when I spin it!

Doug.

Hi,

Sorry for the delay, I don't check here often enough.

I wouldn't recomend the swap.

The engine is a very tight fit but plenty of people have done it.

No swap parts are available but a simple a adaptor plate can be made to work and use an aftermarket (CRS?) flywheel.

If you email me your address I'll send you a write up I did on swapping into an early RR, as it may be of use to you.

Cheers,

Rod

Hi Zuffen, We are seriously considering putting a 1UZ into my 00 Range Rover P38 with ZF. Where can I find bellhousing and necessary parts to mate them? Is it feasible? what are the most challenging parts of this project? Thanks.