LS400 ignition wire splice?

[vltjr]

I replaced my wife's '94 LS400 water pump this weekend with all but one thing going smoothly. When putting the right side distibutor cap cover back on, I apparently left one of the spark plug wires loose or misrouted. When I started the car I heard a flapping sound coming from under the cover, and later discovered that I cleanly sheared a plug wire. Since my ignition wire set is practically new (and I haven't found anyone to sell me a single wire), my question is: can I repair this wire by splicing it back together, or buy some generic ignition wire and reuse my connectors to create a replacement?

Any help would be greatly appreciated by me and my wife.

Thanks.

 

[Jake Breyck]

msd sells a make your own wires set, its about 40$ for the set for a 4cyl it comes with quite a bit of wire ends a crimper block to put into a vise and cripm the ends to the wire and boots of a few types

i ran these on my corolla when i had the 4ag in it, it is good parts.

its too bad i dont have any of the spare wire around, as there is always extra or i would ship out a leingh of it.

 

[Jake Breyck]

ah here you go, and you can order just the wire. and ends and such.

http://www.msdignition.com/wire_3.htm wire and build yer own kits....

http://www.msdignition.com/1sparkplugwires.htm at the bottom of the page, other parts. and crimper tool..