UCF11
Member
I am after a few keyed M90 supercharger pullies.
Accept I need ones which stick out further than the stock type, around 1" (25mm) past the end of the shaft.. if that make sense.
I am guessing might have to get some machined locally as they don't seem to be very common.
Anyone seen any 'extended' M90/M112 pulleys?
Accept I need ones which stick out further than the stock type, around 1" (25mm) past the end of the shaft.. if that make sense.
I am guessing might have to get some machined locally as they don't seem to be very common.
Anyone seen any 'extended' M90/M112 pulleys?
