Bypass Ignition to start Car

[Lextreme II]

Anyone know which wire i should hot wire it in order to bypass ignition switch. I am trying to start the car without the ignition key. I know there are many mechanic shop start the car that way especially they work alone or trying to do timing.

 

[LSKid]

Heres some wiring diagrams i finally figured out how to use my print screen program!

Hope they help! If you need any others dont hesitate to ask!

Good Luck.

 

[Lextreme II]

I have three fuse modules at home and i change them all, but still no luck. I would not be suprise if the Theft Deterrent be the problem. I did tried to put the transmission in N but still no luck. Here is a Starter Electrical Circuit Diagram

 

[Nick M]

I am printing it out. I dont have an EWD for it. I will go over it and see if your proposition is easily doable.

Of coure the real question is why? I think your key is "chipped" anyway, and you still have to put it in the ignition.

 

[Nick M]

Are you trying to crank the engine over for diagnostic purposes, or actally trying to start it?

 

[Lextreme II]

I was trying to test the starter without relay, ignition and other systems involved.

 

[Nick M]

edit: never mind, I just thought about where your starter is.

You need to remove the circuit opening relay and simply ground the starter relay. Grounding the starter relay will power the circuit opening relay, which is why I am saying to remove it.

Then clear all the DTC's you are going to set by doing that.

 

[Nick M]

Even easier yet is remove the circuit opening relay, and put a jumper wire in place of the starter relay.