1uzfe wiring loom swap-help

[nasho82]

Hi All,

I currently have a 1uzfe from a crown (mid Sump) that has had the transmission loom cut off and I'm also without the transmission computer.

My aim is to run the auto.... Does anyone know if it is possible to use another 1uzfe wiring loom and computer on a crown 1uzfe. Eg from a Soarer????

NB: This is being converted into a nissan Navara ute.

Any help would be appreciated.....Cheers

 

[sideshow]

u can use any loom u just have to make sure u rewire it to suit the new ecu

if yr just missing the auto section i have afew of these cut out from other jobs ive done
i can send it up to u

and i also have an auto ecu to suit the twin ecu crown engines

but before u spend money on this make sure u have everything to match

like ignitors
engine ecu
air flow meter

anyway just remember its a big job getting all the navara dash working correctly
toyotas have square wave spedd signal
nissans are usually sine wave signal
i had a nissan once with a 1j and ended up costing a fortune to get tacho and speedo accurate
might be worht going aftermarket