p0340

  1. T

    1uz vvti rough at low revs

    Hi, pulling my hair out with this one. My 1uz vvti swapped hilux has been running fine for years. Last week it started to judder and miss at idle. I was 70 miles from home so I had to drive it back, strangely at about 3k it wakes up and not just slowly, imagine a turbo kicking in. Plugged it in...
  2. D

    NEED HELP 96 sc400 Electrical

    I’m going to try and make this as short winded as possible. 1996SC 400 P0340 camshaft positioning sensor circuit bank one sensor one. Changed out crankshaft positioning sensor both camshaft sensors I still get this code right away it doesn’t even make it up the driveway before the check engine...
  3. J

    97 non-VVTi Stalled now No-Start

    Hello all! Long story short: I picked this up cheap because of failed front seals. Replaced seals and timing belt. Had some funky ECU issues (wouldn't read being the primary), so I pulled it and changed out the capacitors. After 5500 miles of smooth driving it shuts down, throws a CEL, won't...
  4. J

    p0340 wtf can not remove it even after following procedure

    engine is a jdm 2002 celsior 3uz-fe car is 96 hilux So the scanner says p0340 is cam position sensor however if I unplug that sensor, it throws a vvt sensor code (p1345). Ive replaced the vvt sensor bank 1, both bank plugs and check for shorts/continuity all fine. The resistance on the old...
  5. B

    1UZ VVti Wiring Diagrams (98-00 LS400)

    Hi all, I've compiled a package of wiring diagrams and diagostic procedures for the 1UZ-FE VVTi (specifically 1998-2000 LS400). The diagrams cover a variety of circuits, including ECU, auto transmission, AC, starting and charging, multiplex, shift lock, radiator fan, and more. Also included...
  6. X

    Does the 1st gen 1uzfe have 2 cam sensors?

    I still can't find the answer to this :( And the reason I ask is because when I go to order one it gives the option of left and right however I thought it was just one on the left bank? Please correct me if I am wrong . Thanks
  7. X

    P0340 97 sc400 cam sensor code??

    So I have this code being thrown randomly and also have what seems like a rev limiter at the wrong rpm's only sometimes but part throttle it drives just fine as it should. My question would be is the distributor considered the cam sensor or is there an actual cam sensor that I am missing...
  8. W

    97 ls400 engine light on with ticking noise

    97 ls400 with 204500 miles, engine light on code P0340 camshaft position sensor bank 1, also ticking noise, rough idle, hesitation, loss of power when acceleration if press more on gas car jerks and hesitates. my mechanic has replaced both camshaft sensors, engine cooling temp sensor, cleaned...


Back
Top