obdii

Hello, I have a 1996 OBD2 1UZ in a Nissan 240sx. Ive got the thing up and running and id like to pull the codes. I cant seem to find any information about pulling codes on an OBD2 without using a scan tool. Is there a way to do this without a scan tool? So Far i have tried grounding the T1...

So, I'm trying to get my OBDII port up and running. As I understand it, the OBD Port is Data Link Connector 3 Following the wiring diagrams, I see there should be 4 pins wired up on the plug: pin 7 - SIL (with a grounded shield) pin 16 - +12V pin 4 - CG (grounded) pin 5 - SG (grounded) I...

On the '98 LS400 OBDII port, The U.S. version I believe has 4 wires going to it 4,5,7 & 16 and the Australian version has 5 wires 4,7 9,13 & 16. Does anybody know why this is and whats different about it ? I recently bought a code reader/scanner and i think this is why it doesn't work properly...

Hey guys i put a 1uz into a toyota pickup offroad race truck and have it all up and running but need to diagnose an issue but cant seem to figure how to wire a cel. Am this far. I connected te1 and e1 in the engine diagnostic plug but can not find which wire coming out of the ecu to trip...

Have anyone ever seen this? http://www.scantool.net/ Wireless Bluetooth OBDII reader to Laptop/Netbook.

I am looking at doing a OBD II 1uzfe setup for my toyota pickup, and was wondering if there is any difference between a pre 96 engine as to a OBD II year engine for this build. is there any difference between the wiring harness on these two other than the connection to the ecu, and would a OBD...

Hi Guys, Found the following on a English site, outlines how to jumper the diagnostic ports for various tests, may be of help to someone out there. Regards Lambo The Soarer has a complete onboard diagnostic system that when run will show up most faults if you are having problems. The...