Search results

No the plugs to the ECU are different, Probably other things as well

How did you work out your primary and secondary sizes?

I have a Majesta with ecu with 3 40 pin plugs.The sensor at the rear of the transmission tells the computer how fast it is going. The abs works off speed sensors at each wheel . You must be revving awful fast to get 70kph in first low I am lucky to get that in first high.

I retained the speed sensor between the transmission and transfer have had no problems. If you dont want to put it in you could try multiplying the signal from the cluster when in low range.

Did you read this thread? http://lextreme.com////forums/showthread.php?t=3103

QUOTE 75L for 300km @ 170km/h? something's wrong with your car. the harshiest fuel consumption i could achieve with my SC400 was 15L/100km, and that was hard city driving only. He said he did 600ks on 75L thats about 12.5l/100k. My RX5 used to use about 18L/100k cruising at 180kph...

The 1UZ alternator has the regulator built in so no external one is needed.

A pic of the surf sensor rotor and the a341e four pronged rotor. The a341e rotor will have to be reduced in length to fit and fixed to the shaft

Here are the 2 housings back to back showing the sensor hole differences

Here is the end of the a341e transmission with the location of the hole which has to be drilled and tapped to 10mm

Here is a pic of a341e Soarer output shaft with rotor. The shaft has to be cut to length

You can alter the a343f to fit up to the 1uz and you will have issues with sending speed signals to the ecu to control the transmission. Or you can keep the a341e which came with the 1uz and fit it to the surf transfer and you will have all the correct signals going between the ecu and the auto...

I can send you a Number 3 lead and a coil lead. $5 for postage if you want it.

I made my own as well 2x2inch running into 2.5inch in ss not so hard

When I was at Australia Zoo Steve took great delight teasing this female crock which had its nest just to Steves right. He only just got away from it that day.

Compressor arrived this morning Thank you Kris

Part number for the "strainer assembly" for the UZZ30 is 35530-50010

Here is a picture of the filter screen in my A341H . You can see it through the rectangular hole.

I offered Rivmaster $100 dollars for a compressor he had . He accepted but never came good with it. I would be happy to give $100 plus postage for it .