Search results

I just resized the heading is wrong FLEXPLATE - TORQUE SETTING FOR BOLTS TO FLYWHHEL should say toCRANK I recently replaced the rear main seal and to do so I had to remove the flex plate which is bolted to the crank. I'm talking about the flex plate bolts into the crank, (or flywheel in case...

Did a search couldn't find anything, my question is;- What should the flexplate bolts be torqued up to?

....and where is the idle speed valve located.

Thank you for that gloverman! Just one thing, You lost me there, What is this extra box you speak of?

Engine is a 1uz from a Celsior with a chopped loom. I'm using a Microtech LT-10s with X4 ignitor (not pictured) with comes with a full engine loom. This Microtech loom looks dead simple, all pre marked with intructions...idiot proof. Now. On the factory loom, what are these plugs used for...

Just picked up motor from importer, its a Celsior 1uz front sump, and upon removal of the lexhaust maifolds I noticed these two cracks in the alloy boss for the exhaust stud. It would appear that is has been overtightened by some tard at some stage. Picture is of the left hand side bank (right...