Recent content by George_R

there were at least 4 types of 1gz pinouts be more specific start with ecu part code

M112 more details

https://all4swap.ru/contact Phoenix is temporarily not available but your ECU can be remapped by my other partners located in NZ, USA and UAE Also you can buy compatible remaped ecu from UAE all possible improvements : Toyota/Lexus ECU Remap - All4Swap

1) most likely, your ecu was not programed for m/t properly 2) next thing is that, most likely, it is not wired properly at the same time

what are your long term fuel trims for bank1 and 2 at idle ant 3000rpm? what's your mass airflow (g/sec) at idle?

sure just look at your 3uz wiring diagram and connected reverse lights per it

this device may help, it activates various modes that were available from factory (including idle up) but are no longer available in your not so professional swap https://all4swap.ru/product/mpx-fan

We have a device to fix a/c , abs, dsc, and dash for 3uz into e46/e39 conversions https://all4swap.ru/product/e46

https://www.lextreme.com/scan-tools-for-toyota-engine-swaps/

You can put 2002 sc430 engine , transmission and ecu into anything and once wired properly it will work properly. Stock ABS is not required.

https://www.lextreme.com/scan-tools-for-toyota-engine-swaps/ lexus-doc.ru

Get a modified valve body for quicker shifting

none of aftermarket ecus is compatible to dash, a/c , trc/vsc system dash and a/c can be partly fixed by additional device though

https://www.lextreme.com/scan-tools-for-toyota-engine-swaps/

Cel is connected to ecu pin W, active low. Wire an extra small bulb or led and see if it works. It may not work because of ecu aging or other problems that you should expect in 30 year old car